yooTen Sensors

Wet sink - The load is energized ("ON") as long as the sensor tip is immersed in fluid.Dry sink - The load is energized as long as the sensor tip is dry (i.e. not immersed in fluid).

The term "intrinsically safe" refers to equipment and wiring which is incapable of releasing sufficient electrical or thermal energy under normal or abnormal conditions to cause ignition of a specific hazardous atmospheric mixture in its most easily ignited concentration.

A sensor in the context of the Internet of Things (IoT) is a device that detects and measures physical parameters from its environment, such as temperature, humidity, motion, or light, and converts them into signals that can be processed, transmitted, or stored.

A pressure sensor converts the pressureinto a proportional electrical signal (usually 4-20 mA, 0-10 V or digital fieldbus).

A pressure switch is basically an electrical switch that turns on or off at a preset pressure level. When the thresholdis reached, an internal micro- or macro‐mechanical element (diaphragm, bellows or piezo‐kit) is activated that closes or opens a contact.

Engineers created a compact sensor with infrared imaging for drones, enhancing crop management by allowing for precise irrigation and pest control, which could lower grocery prices and boost harvests.

Today we will introduce the most important part of the pressure switch manual, how to adjust the set point.Firstly, we need to understand some characteristics of Anfield pressure switches.

As part of Anfield pressure switch installation instructions, this article introduces the electrical rating of pressure switches. The following is a table of electrical ratings and circuit diagram.

The Anfield pressure switch manual provides more detailed descriptions of product performance and explains the process of adjusting the set points later in the text.

Many Gems sensors products offer a linear 4-20 milliamp (mA) output signal for transmitting to a receiver (meter/display, PLC, etc.) when measuring level or pressure. It is good to know the basics when troubleshooting or when choosing the best output signal for your application.