yooTen Sensors

Engineers created a compact sensor with infrared imaging for drones, enhancing crop management by allowing for precise irrigation and pest control, which could lower grocery prices and boost harvests.

Today we will introduce the most important part of the pressure switch manual, how to adjust the set point.Firstly, we need to understand some characteristics of Anfield pressure switches.

As part of Anfield pressure switch installation instructions, this article introduces the electrical rating of pressure switches. The following is a table of electrical ratings and circuit diagram.

The Anfield pressure switch manual provides more detailed descriptions of product performance and explains the process of adjusting the set points later in the text.

Many Gems sensors products offer a linear 4-20 milliamp (mA) output signal for transmitting to a receiver (meter/display, PLC, etc.) when measuring level or pressure. It is good to know the basics when troubleshooting or when choosing the best output signal for your application.

The correct installation position of the pressure transmitter on the process pipeline is related to the measured medium. In order to obtain the best measurement effect, the following points should be considered during installation and maintenance:

There are two main types of pressure switches: mechanical pressure switches and electronic pressure switches. Mechanical pressure switch; Electronic pressure switch

A pressure transducer is a device that converts pressure into an electrical signal. It is also known as a pressure sensor or pressure transmitter. The following are common applications of pressure transducers.

How to set the set point of RFS flow switch? With the unit installed in the line and power supplied, complete the following steps to calibrate switch actuation point with a proper flow rate. A small flat-blade screwdriver is the only tool required.

There are a lot of companies considering in-house automation or consulting with integrators for automated systems. But where do you start, and how do you even pick a project for automation?